follow:
Aftermarket online service: Alen@china-balin.com
HOW TO TEST COMMON RAIL INJECTOR WITH TOOLS?
Time:2019-09-05
Pageviews:1695
Share:
injector tester
(1)Common rail test tools:
Common rail injector nozzle tester S60H + Common rail injector drive CR-C
fuel injector tester
(2)Injector tester S60H introduction:
- Diesel nozzle tester Pressure Gauge:0-60Mpa or 0-8000 Psi
- Function:Adjust injection nozzle opening pressure and carry out leakage, spray pattern and chatter characteristic tests
- Application:Diesel Injector Repair Tools
- Advantage:Durable, Light, easy to operate
- Material:Iron, Plastic
- Body color:Black
- Brand:BASCOLIN
- Net weight:3.8KGS
- Gross weight:5KGS
- Carton Size:45.5(cm)*26(cm)*17(cm)
- Packaging Details:1set/carton
diesel injector tester
(3)CR-C multifunction diesel common rail injector tester introduction:
- Accurately and effectively to imitate ECU drive signal for each work condition of injector,including pre-injection, emission point, full load point conditions.
- Easy operate to test with the injector hand pumps
- Small size and light weight
- Test application for BOSCH,DENSO,DELPHI common rail injectors 
- Power Supply: AC110v-240V
- Working Temperature: -30C°-70C°
- The adjustable pulse width:10MS
- Adjustable frequency:30HZ
- Operator Interface
- LCD screen: The upper left corner of the instrument is used to display the frequency pulse width value.
- Indicator light: to show current status and drive mode.
- Size:110*250*190mm
 
(4)Buttons Introduction:
- Button of Run & Stop:to turn on and off the signal output.
- Drive mode:Select the drive mode by the left and right keys.
- MS knob: to adjust pulse width.
- HZ knob: to adjust frequency.
- Signal outlet: to connect injector harness.
- Power supply: to turn on and off the main power
- Operational Method
 
(5)How to test common rail injectors?
1.Load common rail injector into the clamp and connected to the common hand pressure calibrato
2.Select the appropriate plug according to the injector brand and then connect the wiring harness to the injector.
3.According to the injector brand, select the corresponding drive mode. At this time, you can hear the injector solenoid valve suction armature "pa,pa" sound.
4.Provide the proper injection pressure by continuously lowering the lever of the calibrator. The general pressure value is 30-40MPA, and the atomization performance of the injector can be observed at this time.
5.Through the external cylinder, fuel oil quantity and return oil quantity of fuel injector can be detected.

If you are interested in these common rail injector testing tools & equipment,you could order from our official store link as below:
S60H Injector tester:

S60H tester + CR-C Injector Drive:

CR-C Injector Drive: